Do you know how important to adjust bearing after the bearing is installed?

Jan 30, 2023

Leave a message

After the bearing is installed, add the specified lubricant, and then conduct a test run to check whether there is noise and the temperature of the bearing.

The test run should be carried out under the condition of partial load, and in the case of a large speed range, it should be operated at a medium and low speed.
In any case, spherical roller bearings should not be started under no-load conditions and accelerated to high-speed operation, because the rolling parts may slide on the bearing raceway, damage the raceway, and the cage may also bear impermissible pressure. Under normal conditions, the bearings will make a uniform "grunt" sound.
A whistling or screeching sound from a bearing indicates insufficient lubrication.

Uneven rumbling or thumping noises from bearings are mostly caused by debris in the bearing, or the bearing was damaged during installation.
It is normal for the bearing temperature to rise immediately after starting.

For example, in the case of grease lubrication, the bearing temperature will not drop until the grease is evenly distributed inside the bearing, after which an equilibrium temperature will be reached.
Abnormally high temperature or a large increase in temperature indicates that there may be too much lubricant inside the bearing, or the bearing has radial or axial deformation, or the clearance is too small. Other reasons include improper manufacture or installation of related components, or excessive friction of seals.
During the test run or just after the test run, the seal should be checked to see if it works normally, and the lubricating equipment and the oil level of the oil tank should also be checked. Lubricant samples may also be taken to determine if the bearing interior is contaminated, or if parts inside the bearing are worn.
info-1080-515

Send Inquiry