Important killers affecting bearing life

Oct 22, 2021

Leave a message

Installation and sealing:


The installation of the bearing has a great influence on the life. The installation of the bearing requires good concentricity, the sealing device prevents the intrusion of dust, particles and water, and the working radial clearance should be adjusted appropriately.


 Dynamic load:


When stuck steel, cold rolled steel, and foreign objects enter the roll, it will cause 10 to tens of times the impact force. Therefore, the operation of the rolling mill should be standardized to prevent the stuck steel and other phenomena to avoid early fatigue damage of the bearing.


temperature:


If the operating temperature exceeds 120 degrees Celsius, the temperature of the rollers and raceways will be higher (about 150 degrees Celsius), which will exceed the tempering temperature of common bearings, and the hardness and dimensional accuracy of the bearing will greatly reduce grease failure.


lubricating:


Poor lubrication will cause excessive friction and temperature rise, which will cause early damage to the bearing.


 Premature damage to the bearing caused by various use or environmental factors is a great waste of resources. Prolonging the service life of the bearing can be said to have important social significance in energy saving, environmental protection, and resource saving.


Analysis of common damage causes of large-size bearings


And life-prolonging preventive measures


A. Improper operation


Improper installation, operation or disassembly may cause deformation or defect of the cage.


Precautionary measures: Use appropriate operation, installation and removal tools.


B. Insufficient lubrication


Insufficient or improper lubrication may cause component scratches or severe bearing deformation.


Preventive measures: improve the lubrication system, replenish or replace the lubricant regularly and appropriately.


C. Rust and corrosion


Contact with water may cause corrosion and rust of bearing components, and rust-damaged bearings may peel off during operation.


Preventive measures: Check the seal regularly to ensure a good sealing effect and store the bearing correctly.

D. Current


When the bearing is rotating, energization may cause grooves or nicks. When the bearing is stationary, improper electrical operation can cause minor burns.


Precautionary measures: Before welding parts other than the bearing, reduce or avoid current passing through the bearing through proper grounding connections.


E. External materials


Contamination of abrasive particles and intrusion of debris can cause wear, abrasion and dents on the bearing working surface.


Preventive measures: remove invading particles and debris, replace lubricant, check the sealing system.


F. Eccentricity


Eccentricity, tilt or excessive load may cause geometric stress concentration or surface peeling.


Preventive measures: precision machining of bearing seats and shoulders.


Send Inquiry