Installation Of Thrust Angular Contact Ball Bearings

Oct 23, 2019

Leave a message

1. The bearing installation should be carried out in a dust-free and clean room. The bearings should be carefully selected. The bearing spacers should be ground. Under the premise of keeping the inner and outer ring spacers high, the parallelism of the spacers should be controlled at 1um. the following.

2. The bearing should be cleaned before installation. When cleaning, the inner ring slope is upward, the hand is sensitive, there is no sense of stagnation. After drying, put a specified amount of grease. If it is oil mist lubrication, put a small amount of oil mist oil.

3. The bearing should be installed with the door tool, the force is even, and it is forbidden to knock.

4. The bearing should be clean and ventilated, free of corrosive gas, and the relative humidity should not exceed 65%. It should be regularly rust-proof for long-term storage.


Send Inquiry